收藏本站
NCP5010
Finally an acceptable DCR must be selected regarding
losses in the coil and must be lower than 1.4 W to limit
excessive voltage drop. In addition, as DCR is reduced,
overall efficiency will improve. Some recommended
inductors include but are not limited to:
TDK VLF4012AT?220MR51
TDK VLP4612T?220MR34
TDK VLP5610T?220MR45
Coilcraft LPO6610?223M
Coilcraft DO1605T?223MX
Coilcraft DT1608C?223
reaches 66% of V IN , then the PWM circuitry is enabled. In
normal conditions when the device is enabled by an active
high signal on CTRL, the short circuit condition continues
until the output capacitor is charged by the limited current
up to 66% of V IN .
V OUT
2/3 V IN
1/2 V IN
Capacitor Selection
To minimize the output ripple, a low ESR multi?layer
Normal
Running
SC Short?Circuit Condition End of Short?Circuit
Occurs Current limited at 20mA Detected Converter
Converter in Standby
Starts Again
T
ceramic capacitor type X5R or equivalent should be
selected. For LED driver applications a 1 m F (min) 25 V is
adequate. The NCP5010 can be operated in a voltage mode
configuration (see Figure 34) for applications such as
OLED power. Under these conditions, C OUT can be
increased to 2.2 m F, 25 V or more to reduce the output
ripple.
The input needs to be bypassed by a X5R or an equivalent
low ESR ceramic capacitor near the V IN pin. A 1 m F, 6.3 V
is enough for most applications. However, if the connection
between V IN and the battery is too long then a 4.7 m F or
higher ceramic capacitor may be needed. Some
recommended capacitors include but are not limited to:
TDK C1608X5R1E105MT
TDK C2012X5R1E105MT
TDK C1608X5R0J105MT
TDK C2012X5R1E225MT
Murata GRM185R61A105KE36D
Murata GRM188R60J475KE19D
Murata GRM216R61E105KA12D
Short?Circuit Protection
If V OUT is falls below 50% of V IN then a short?circuit
condition is detected. When this event is detected, the
PWM circuitry is disabled and the NMOS power switch is
not turned on. Power will be supplied to the load through
Figure 27. Example of the V OUT Voltage Behavior
When Short?Circuit Arises
Overvoltage Protection (OVP)
If there is an open load condition such as a loose
connection to the White LED string, the converter will
provide current to the C out capacitor and the voltage at the
output will rise rapidly. This could cause damage to the part
if there was not some external clamping Zener clamping
circuit. To eliminate the need for these external
components, the NCP5010 incorporates an OVP circuit
which monitors the output voltage with a resistive divider
network and a comparator and voltage reference. If the
output reaches 22 V (nominal), the OVP circuit will detect
a fault and inhibit PWM operation. This comparator has
1 V of hysteresis so when the load is reconnected and the
voltage drops below 21 V, the PWM operation will resume
automatically. The 22 V OVP threshold allows the use of
25 V ceramic capacitors for the output filter capacitor.
Undervoltage Lock Out (UVLO)
To ensure proper operation under all conditions, the
device has a built?in undervoltage lock out (UVLO)
circuit. During power?up, the device will remain disabled
until the input voltage exceeds 2.4 V nominal. This circuit
has 200 mV of hysteresis to provide noise immunity to
transient conditions.
the inductor, rectifier and high side switch. Once V OUT
http://onsemi.com
11
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
NCP5021MUTXG IC WHITE LED DVR HV AMB 16-UQFN
NCP5050MTTXG IC LED DRIVR PHOTO FLASH 10-WDFN
NCP5111DR2G IC DRIVER HI/LOW SIDE HV 8-SOIC
NCP5304DR2G IC DRIVER HI/LOW SIDE HV 8-SOIC
NCP5355DG IC DRVR SYNC BUCK MOSF 12A 8SOIC
NCP5359ADR2G IC MOSFET GATE DVR DUAL 8-SOIC
NCP5359DR2G IC GATE DRIVER VR11.1/AMD 8-SOIC
NCP5360RMNR2G IC DRIVER MOSFET 56QFN
相关代理商/技术参数
NCP502 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:80 mA CMOS Low Iq Voltage Regulator in an SC70−5
NCP502 K20PA WAF 制造商:ON Semiconductor 功能描述:
NCP502/D 制造商:未知厂家 制造商全称:未知厂家 功能描述:80 mA CMOS Low Iq Voltage Regulator in an SC70-5
NCP502_07 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:80 mA CMOS Low Iq, Low−Dropout Voltage Regulator
NCP5021 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:High Voltage White LED Driver with Ambient Light Sensing
NCP5021MUTXG 功能描述:低压差稳压器 - LDO NCP5021 RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20
NCP502ASQ15T1 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:80 mA CMOS Low Iq Voltage Regulator in an SC70−5
NCP502ASQ15T1G 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:80 mA CMOS Low Iq, Low−Dropout Voltage Regulator